Improve the productivity：
Mold cleaning sheets for semiconductor manufacturing processes

Continuous molding work in semiconductor sealing processes causes resin to adhere to molds, making them dirty due to generated gas. Regular cleaning and shorter cleaning time are required to reduce loss in semiconductor manufacturing processes and to maintain the quality. Our mold cleaning sheets can be used to clean in the same process as product molding. In addition, they realize cleaning in fewer processes than conventional cleaning methods, helping increase productivity.

Innovative Solution

Significantly reduce the number of shots in mold cleaning and manufacturing costs

One of the mold cleaning methods in semiconductor sealing processes is to transfer stains from the mold surface with a cleaning material composed of melamine resin. Because cleaning with melamine resin is specialized for cavities, the method is not good at cleaning air vents and parting surfaces, requiring at least 10 shots^※ to remove stains. The improvement of the efficiency of cleaning processes and shorter cleaning time are required to reduce manufacturing costs.
Our mold cleaning sheets in the <N-CS Series> are cleaning materials composed of thermosetting synthetic rubber. Because they are made of synthetic rubber, you can fill entire mold surfaces including cavities and parting surfaces with cleaning materials by placing sheets on a mold, sandwiching them between molds, and heating it. This process removes stains caused by gas, thin burrs, and clogging of air vents. In addition, the cleaning agent contained in the sheets dissolves stains and removes stain components by transferring them to the sheet; therefore, the mold can be cleaned with fewer shots than cleaning with melamine resin. The sheets shorten cleaning time, which helps boost productivity. They can be applied to both transfer molding and compression molding processes.

Cleaning Performance of Mold Cleaning Sheets ^※

• ※ The graph above shows the cleaning performance as index after continuous molding work (300 shots) with our sealant. If burned stains are accumulated in a mold, a large number of shots will be required to remove them. Moreover, mold cleaning sheets may stick strongly to the accumulated stains. In that case, an overhaul of the mold is required: for example, continuous cleaning with mold cleaning sheets until the level of stains reduces to zero, and full cleaning or re-plating of molds.

Product Features

Shortens mold cleaning time by up to 30% (compared with cleaning with melamine resin) ^※

Cleaning with our cleaning sheets requires a smaller number of shots than melamine resin; therefore, the sheets can shorten the required time per cleaning by up to 30%.

Simulation: how our cleaning sheets shorten cleaning time

• ※ Conditions: Target molding material: Green compound, Target mold: mold for sealing materials (This simulation was performed by Resonac Corporation.)
• ※ If burned stains accumulate in the mold, more shots are required than shown above.
• ※ The combination of mold cleaning sheets and the number of shots vary depending on the molding material.

Two types are available so they can be applied to various shapes of molds.

The level of filling in molds varies depending on the design of cavities on your molds and the orientation of the cleaning sheet arrangement. We offer two types: Standard Type and Excellent-Filling Type. We propose the product lineup that best suits your conditions.

Terms of use (Recommended)

• Molding method: compression molding/transfer molding
• Mold: vertical type
• Mold application temperature: 150 to 190℃
• Target: thermosetting resin such as epoxy resin

N-CS-7500 and N-CS-3700 can be stored at cold and dark place (below 35℃).

Update date: 5th June, 2023